Clamp check valve is a universal one-way fluid valve. Lianggong Valve Factory tells you that it is lightweight, small in size, and easy to install between flanges. The interior of the valve consists of two semicircular springs and a plate surface. The spring deformation of the valve is fixed to the valve body through a pin, causing the valve plate to close. The fluid pressure causes the spring to open quickly, which can protect the pipeline from water hammer damage.

良工閥門

Lianggong Valve

良工閥門提醒安裝注意事項：

Lianggong Valve Reminder Installation Precautions:

放置管道時，應注意使夾式止回閥的通向與流體流向一致；

When placing pipelines, attention should be paid to ensuring that the direction of the clamp check valve is consistent with the flow direction of the fluid;

安裝在垂直放置的管道中。對于水平放置的管道，垂直放置夾式止回閥；

Installed in vertically placed pipelines. For horizontally placed pipelines, vertically place clamp check valves;

將伸縮管用于夾式止回閥和蝶閥之間，切勿將其與其他閥門直接連接；

Use the expansion tube between the clamp check valve and butterfly valve, and do not directly connect it to other valves;

避免在閥板操作半徑范圍內(nèi)加入管接頭和堵塞物；

Avoid adding pipe joints and blockages within the operating radius of the valve plate;

不能在夾式止回閥前或后安裝變徑管；

It is not allowed to install a reducing pipe in front or behind the clamp check valve;

對夾式止回閥安裝在彎頭附近時，要注意留有足夠的空間；

When installing the clamp type check valve near the elbow, it is important to leave sufficient space;

對夾式止回閥安裝在水泵出口時，至少流出六倍閥門直徑的空間，以確保蝶板受流體影響。

When installing the clamp type check valve at the outlet of the water pump, there should be at least six times the diameter of the valve to ensure that the butterfly plate is affected by the fluid.